M400 Web Browser Interface
432-0012-00-12 Version 110 July 2016 33
•The expert log in, shown below, can use the Live Video page, the Setup page, the
Maintenance page Server menus, and can reset the user password or select to allow the user
log in account to change their own password, as well as restrict access to specific IP
addresses.
Maintenance->Sensor->Communications->VMS Remote
Enable ONVIF v2.0 Driver
Enable the ONVIF driver to connect the camera to a VMS or a network video recorder.
1. On the Maintenance->Sensor->Communications->VMS Remote page, select INTERFACE 1.
2. Select Yes to enable driver.
3. Scroll down and select Save.
4. Stop and start the server to make the change effective.
Figure 3-5: Security Options Page (expert log in)
Scroll down
to Save
Select Yes to
enable driver
Stop and start the server
Select Interface 1
for ONVIF driver
To Next Page
Loading...
Need help?
General
