Fluke 5080A - MEGOHM Option Calibration

Calibrator
SC200 Calibration
59
Table 42. Required Test Equipment for SC200 Calibration (cont.)
Test Equipment Recommended Model Minimum Specifications
Edge Frequency, AC Voltage Frequency Verification
Frequency Counter
PM 6680 with PM 9678
option
20 ms to 150 ns, 10 Hz to 10 MHz:
<1.6 ppm uncertainty
BNC Cable (supplied with SC200)
Edge Duty Cycle
Frequency Counter PM 6680
BNC Cable (supplied with SC200)
Leveled Sine Wave Flatness (High Frequency) Calibration and Verification
Power Meter Hewlett Packard 437B
Range -42 dBm to +5.6 dBm
Frequency 10 MHz – 300 MHz
Power Sensor Hewlett Packard 8482A
Range -20 dBm to +19 dBm
Frequency 10 MHz – 300 MHz
Power Sensor Hewlett Packard 8481A
Range -42 dBm to -20 dBm
Frequency 10 MHz – 300 MHz
30 dB Reference
Attenuator
Hewlett Packard 11708A
(supplied with HP 8481D)
Range 30 dB
Frequency 50 MHz
Adapter
Hewlett Packard
PN 1250-1474
BNC(f) to Type N(f)
BNC Cable (supplied with SC200)
Leveled Sine Wave Frequency, Time Marker Verification
Frequency Counter
PM 6680 with Option (PM
9621, PM 9624, or
PM 9625) and (PM 9678)
2 ns to 5 s, 50 kHz to 500 MHz: <1.6 ppm
uncertainty
Adapter Pomona #3288 BNC(f) to Type N(m)
BNC Cable (supplied with SC200)
Wave Generator Verification
AC Measurement
Standard
Fluke 5790A or 5790B
with 03 option
Range 1.8 mV p-p to 55 V p-p
Frequency 10 Hz to 100 kHz
Adapter Pomona #1269 BNC(f) to Double Banana Plug
Termination Feedthrough 50 Ω, +1 %
BNC Cable (supplied with SC200)