726
Users Manual
52
bec25f.eps
Figure 23. Calibrating a Chart Recorder
Remote Control Commands
The Calibrator may be remotely controlled from a PC
running a terminal emulator program. The remote control
commands give access to all capabilities of the Calibrator
with the exception of pressure measurement.
See the Fluke Web Site for the 726 Remote
Programming application note at
www.fluke.com/processtools
HART
Functionality
The Calibrator has a user-selectable 250 Ω HART
to
facilitate use with HART
communication devices. The
resistor can be switched in or out using config selection
menus. Use a HART communicator when measuring mA
with loop power or sourcing mA.
To Next Page
Loading...
