Automatic Pressure Calibrator
Tasks Menu
31
Keypad Test
Use this screen to check the Product buttons. Push any
button and verify the onscreen response.
For the power button, push and hold for 2 seconds.
Exhaust
The Exhaust function releases all pressure inside the
Product including the pressure reservoir. This reservoir
keeps the pressure stable and provides pressure if only
small pressure steps are necessary. Push for
Exhaust.
Tasks Menu
Tasks let you set up calibration and measurement tasks
to save and recall for later use.
To go to the Tasks menu, push . The Tasks menu
has these submenus:
• Pressure Transmitter (P/I)
• Pressure Switch (SW)
• Current to Pressure Test (I/P)
• Pressure Leak Test
• Pressure Transmitter (P/V)
• Pneumatic Pressure Transmitter (P/P)
Note
P/P tasks require a pressure module connected
to the Product.
To Next Page
Loading...
