Fluke 729 - HART Commands

Automatic Pressure Calibrator
Maintenance
73
HART Commands
See Table 9 for Product HART commands.
Table 9. Supported HART Commands
Number
Command Description
Type
1 Read Primary Variable Universal
2
Read Loop Current and Percent
of Range
Universal
3
Read Dynamic Range and Loop
Current
Universal
8
Read Dynamic Variable
Classification
Universal
12 Read Message Universal
13 Read Tag, Descriptor, Date Universal
14
Read Primary Variable
Transducer Information
Universal
15 Read Device Information Universal
17 Write Message Universal
18 Write Tag, Descriptor, Date Universal
Number Command Description Type
20 Read Long Tag Universal
21 Read Unique Identifier Universal
35
Write Primary Variable Range
Value
Common
Practice
40 Enter/Exit Fixed Current Mode
Common
Practice
41 Perform Self Test
Common
Practice
43 Set Primary Variable Zero
Common
Practice
44 Write Primary Variable Units
Common
Practice
45 Trim Loop Current Zero
Common
Practice
46 Trim Loop Current Gain
Common
Practice
48 Read Additional Device Status
Common
Practice