Automatic Pressure Calibrator
Safety
3
Safety
Warnings and Cautions
A Warning identifies conditions and procedures that are
dangerous to the user. A Caution identifies conditions
and procedures that can cause damage to the Product or
the equipment under test.
Warning
To prevent possible electrical shock, fire, or
personal injury:
• Read all safety information before you use
the Product.
• Carefully read all instructions.
• Do not use the Product around explosive
gas, vapor, or in damp or wet
environments.
• Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
• Do not apply more than the rated voltage,
between the terminals or between each
terminal and earth ground.
• Do not touch voltages >30 V ac rms, 42 V
ac peak, or 60 V dc.
• Do not use the Product if it is damaged.
• Disable the Product if it is damaged.
• Do not use the Product if it operates
incorrectly.
• Use the correct terminals, function, and
range for measurements.
• Remove all probes, test leads, and
accessories before the battery door is
opened.
• The battery door must be closed and
locked before you operate the Product.
• Use only the mains power cord and
connector approved for the voltage and
plug configuration in your country and
rated for the Product.
• Replace the mains power cord if the
insulation is damaged or if the insulation
shows signs of wear.
• Examine the case before you use the
Product. Look for cracks or missing
plastic. Carefully look at the insulation
around the terminals.
To Next Page
Loading...
