Fluke 729 - HART Menu; HART Data; HART Service; Calibrate (Ad Hoc)

Automatic Pressure Calibrator
HART Menu
45
Enable HART 250 Ω
The Product has a selectable 250 Ω HART resistor to
facilitate use with HART devices. Enable the HART resistor
when you connect the Product to a HART device. The
HART resistor defaults to OFF.
To turn on or off the HART resistor, push  (Enable
HART 250
Ω) or Disable HART 250Ω).
HART Menu
The HART menu has these functions that configure and
calibrate a HART device:
• HART Data
• HART Service
• Calibrate (Ad Hoc)
• Find Task by Tag
• Bus Polling
From the HART menu, push  (Disconnect) to
disconnect from HART communication, or push 
(Continue) to continue to the highlighted entry.
HART Data
The HART data screen shows information about the
connected HART device. Push  (Page Up) or 
(Page Down) where necessary.
You can modify certain fields that include:
• Tag ID
• PV Unit Type
• Lower Range Value (LRV)
• Upper Range Value (URV)
• Damping
• Message
• Descriptor
• Date