Accessory Information
Safety Designed Test Lead Set (TL70)
6
6-11
be made without breaking the circuit under test. This coil serves as the
secondary of a 1:1000 transformer. The current-carrying conductor being
measured serves as the primary.
CURRENT RANGE ......................... 2A to 150A
ACCURACY, (48 Hz to 10 kHz)......
±
2%, 10A to 150A
±
8%, 2A to 10A
DIVISION RATIO............................ 1000:1
WORKING VOLTAGE.................... 300V ac rms max
INSULATION DIELECTRIC
WITHSTAND VOLTAGE...............
3 kV rms
MAXIMUM CONDUCTOR SIZE... 7/16” (1.11 cm)
6-12. Safety Designed Test Lead Set (TL70)
The TL70 Test Lead Set includes one red and one black test lead. Each
probe has an anti-slip shoulder near the test tip and is connected to the
multimeter via a safety-designed shrouded banana connector. This set will fit
Fluke instruments with safety-designed input jacks.
6-13. Deluxe Test Lead Set (Y8134)
The Y8134 is a deluxe test lead set. The attachments provided allow
interconnection with a wide variety of leads and electronic components.
Included in the kit are:
1. Two test leads (one read and one black). The Y8134 leads have a
shrouded banana connectors on each end.
2. Two test probes
3. Two insulated alligator clips
4. Two spade lugs
5. One squeeze hook
6. One test lead pouch
7. One instruction sheet
To Next Page
Loading...
