Product Overview and Specifications
Safety Information 1
1-5
• Use only current probes, test leads, and adapters supplied with the
Product.
• Install the CAT III protective cap of test lead when you use the product
in CAT III environment. The CAT III protective cap decreases the
exposed probe metal to < 4 mm.
• Do not operate the Product with covers removed or the case open.
Hazardous voltage exposure is possible.
See Table 1-2 for a list of symbols used in this manual and on the Product.
Table 1-2. Symbols
Symbol Description Symbol Description
Risk of danger. Important
information. See manual.
AC (Alternating Current)
Hazardous voltage.
DC (Direct Current)
Earth ground. Battery
Fuse CAT II
Measurement Category II is applicable to
test and measuring circuits connected
directly to utilization points (socket outlets
and similar points) of the low-voltage
MAINS installation.
CAT III
Measurement Category III is
applicable to test and measuring
circuits connected to the
distribution part of the building’s
low-voltage MAINS installation.
CAT IV
Measurement Category IV is applicable to
test and measuring circuits connected at the
source of the building’s low-voltage MAINS
installation.
Inspected and licensed by TÜV
Product Services.
Conforms to relevant North American Safety
Standards.
Conforms to European Union
directives.
Conforms to relevant Australian Standards.
This product complies with the WEEE Directive (2002/96/EC) marking requirements. The
affixed label indicates that you must not discard this electrical/electronic product in domestic
household waste. Product Category: With reference to the equipment types in the WEEE
Directive Annex I, this product is classed as category 9 "Monitoring and Control
Instrumentation” product. Do not dispose of this product as unsorted municipal waste. Go to
Fluke’s website for recycling information.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
