Fluke BT521 User Manual

BT521
Users Manual
5-2
View Profiles Saved in Sequence Mode
To view measurement data that is saved in Sequence mode:
1. Turn the rotary switch to VIEW memory.
2. Push M until MEMORY – SEQUENCE MODE shows on the upper left corner of the
display.
The Load profile menu shows on the display.
3. Use  and  to highlight a profile, and push the View softkey.
4. View the memory items, and push the Next softkey to view next page as required.
5. Use 1 to cycle through these four data sets: mΩ.V, Dis.V, VDC, VAC, Ripple,
and Aux.
Delete Profiles Saved in Sequence Mode
To delete data saved in Sequence mode:
1. Turn the rotary switch to VIEW memory.
2. Push M until MEMORY – SEQUENCE MODE shows on the upper left corner of the
display.
3. When the View profile menu shows on the display, use  and L to highlight a
profile, and push the More softkey.
a. To delete only the highlighted profile, push the Delete softkey.
When the display shows Confirm to delete current profile?, push the Delete
softkey.
b. To delete all profiles, push the Delete all softkey.
When the display shows Confirm to delete all profiles?, push the Delete
softkey.

Fluke BT521 Specifications

General

Certification	RoHS, IEC 61326
Product color	Black, Yellow
Frequency range	50 - 60 Hz
Maximum measured voltage	600 V
Minimum measured voltage	6 V
International Protection (IP) code	IP40
Operating temperature (T-T)	0 - 40 °C
Display type	LCD
Built-in display	Yes
Battery voltage	7.4 V

Weight and Dimensions

Depth	58 mm
Width	103 mm
Height	220 mm
Weight	850 g