Fluke BT521 - View Memory; Introduction to Memory Viewing; Managing Meter Mode Data

5-1
Chapter 5
View Memory
Introduction
This chapter provides information about how to view measurement data that is manually
or automatically saved to the Product memory.
The Product has an internal memory that stores measurement data that can be viewed.
Measurement data in Meter mode and Sequence mode shows separately.
View Data Saved in Meter Mode
To view measurement data that is saved in Meter mode:
1. Turn the rotary switch to VIEW memory.
2. Push M until MEMORY – METER MODE shows on the upper left corner of the
display.
3. View the memory items, and push the Next softkey to view next page as required.
4. Use 1 to cycle through these four data sets: mΩ.V, VDC, VAC, Ripple, and AUX.
Delete Data Saved in Meter Mode
To delete data saved in meter mode:
1. Turn the rotary switch to VIEW memory.
2. Push M until MEMORY – METER MODE shows on the upper left corner of the
display.
3. When the data to be deleted shows on the display, push the More softkey.
a. To delete data entries one by one, use and L to highlight a data entry, and
then push the Delete softkey.
When the display shows Confirm to delete the reading?, push the
Delete softkey.
b. To delete all data in the measurement set, push the Delete all softkey.
When the display shows Confirm to delete all readings?, push the Delete
softkey.