Verifying Network Service
Pinging Network Devices
10-11
10
Pinging Network Devices
The ping test verifies connectivity to devices on the
network.
1
To ping a network device:
2
Enter ping addresses in Setup. See page 10-5.
3
Connect to the network as shown on page 10-7.
4
Turn the rotary switch to MONITOR, select Network
Connectivity; then press P.
5
When the network connectivity test is complete, press
L Ping.
6
Do one of the following:
•
To ping one device, highlight the device; then press
P.
•
To ping all devices in the list, press JPing All.
The overall ping result appears on the Network
Connectivity screen. A scroll bar appears if you pinged
multiple devices
7
To see ping details (Figure 10-6), highlight a device;
then press H.
8
To save the ping results, press N. Ping results are saved
as part of the connectivity results. You can save the
network connectivity results in a separate record or
with an existing cable test record. See page 10-6.
To Next Page
Loading...
