Fluke DTX-GFM2 - 2 Tutorials on Setup and Test Procedures; Preparing to Save Tests; Step 1: Checking the Memory Space Available; Step 2: Entering Job Information

2-1
Chapter 2
Tutorials on Setup and Test Procedures
The tutorials in this chapter guide you through setting up
the tester, checking the tester’s status, testing twisted pair
and fiber cabling, and setting up cable ID lists.
Preparing to Save Tests
Step 1: Checking the Memory Space Available
1-1 DTX-1800, DTX-1200: Insert a memory card into the
tester.
1-2 Turn the rotary switch to SPECIAL FUNCTIONS.
1-3 Use D to highlight Memory Status; then press
H.
1-4 DTX-1800, DTX-1200: Press J Int. Memory to switch
between memory card and internal memory status.
Step 2: Entering Job Information
Job information includes the operator name, name of the
job site, and the customer’s company name. These settings
are stored with results you save.
To enter job information:
2-1 Turn the rotary switch to SETUP.
2-2 Use D to highlight Instrument Settings; then press
H.
2-3 Press C to go to the tab with the Operator Name
setting. Press
H to select Operator Name.
2-4 Press J Create; then use JKL,
BCAD, and H to enter your name in the
box. Press N when you are done.
-continued-