Fluke DTX-GFM2 - Setting User Preferences; Changing the Date, Time, and Date;Time Formats; Changing the Length Units; Changing the Numeric Format

DTX Series CableAnalyzer
Technical Reference Handbook
1-24
Setting User Preferences
The following sections describe how to change settings you
may want to adjust when you first start using the tester.
Changing the Date, Time, and Date/Time Formats
1 Turn the rotary switch to SETUP, use D to
highlight Instrument Settings; then press H.
2 Press Cto go to the tab with the Date and Time
selections.
3 Use D to highlight the setting you want to
change; then press
H.
4 To change numbers in the date or time on the Date or
Time screen, use B C to highlight the number; then
use
A D to change the number.
5 Press N when you are done.
6 To change the date or time format, press J Change
Format on the Date or Time screen. Use
D to
highlight the format you want; then press
H.
Changing the Length Units
1 Turn the rotary switch to SETUP, use D to
highlight Instrument Settings; then press
H.
2 Press Cto go to the tab with the Length Units selection.
3 Use D to highlight Length Units; then press H.
4 Use D to highlight the setting you want; then
press H.
Changing the Numeric Format
The tester can show decimal fractions with a decimal point
(0.00) or a comma (0,00).
1 Turn the rotary switch to SETUP, use D to
highlight Instrument Settings; then press
H.
2 Press Cto go to the tab with the Numeric Format
selection.
3 Use D to highlight Numeric Format; then press
H.
4 Use D to highlight the setting you want; then
press
H.