To Next PageTo Next Page
Need help?Do you have a question about the Focus Microwaves ituner and is the answer not in the manual?
General| Brand | Focus Microwaves |
|---|---|
| Model | ituner |
| Category | Tuner |
| Language | English |
Steps to configure the computer's IP address for network communication with the iTuner.
Procedure for establishing a network connection with a single iTuner device.
Steps to connect multiple iTuner devices via an Ethernet HUB.
Details various commands for controlling the iTuner's functions and parameters.
Immediately terminates all tuner movements.
Clears calibration data and resets motor control ICs and tuner axes.
Used to set the static IP address, Netmask, and GateWay of the tuner.
Commands related to moving and querying the position of the tuner's probes.
Initializes all or selected axes of the tuner to their home position.
Positions the tuner's probe to a specified location.
Executes a relative movement for a specified axis.
Commands for tuning the iTuner, including calibration and impedance queries.
Commands for tuning and querying impedance values, requiring valid calibration.
Loads calibration data into the tuner's memory using a calibration index.
Loads calibration data for a specific primary frequency within a given range.
Defines S-parameters for the adapter section between DUT and tuner.
Sets reflection coefficient and moves the probe to the new position.
Moves the probe to a new position based on VSWR value and phase.
Commands designed for straightforward constant VSWR testing.
Performs a 360° phase sweep, adjusting vertical axis to keep VSWR constant.
Initializes axes and obtains VSWR in DUT reference plane.
Overview of programming the iTuner using the iTunerX ActiveX control, including properties, methods, and events.
Properties available for the iTunerX ActiveX control.
Property to set or get the IP address for communication with the tuner.
Methods available for the iTunerX ActiveX control.
Sets or gets the reflection coefficient (gamma) and loss.
Sets or gets the VSWR and loss values.
Procedure for performing tuner calibration using Load Pull Explorer.
