Focus Microwaves ituner - 4.2.2 Stop Command

iTuner Manual
16
SN#: 1
MfgDate: MAY/31/2006
IP: 10.0.0.1
TYPE: 0
MODE: LOAD
TuneParam: 5 -40.00dB 2.00degr
Fmin: 800MHz Fmax: 7000MHz CrossOver: 0.000MHz
Axis# Motor# Init Top Steps Ctrl Limit Current Backlash
#1 1 250 8000 200 4 7365 800mA 0
#2 2 300 15000 500 4 10100 950mA 0
Remarks:
Important configuration data displayed:
 IP address
 Mode (Load or Source)
 Tuning parameters: iterations, Error, PhaseError
 Frequency definitions
 Axis parameters: acceleration, speed, limits,current etc.
Please refer to the corresponding setting command for detailed information on
the above configuration data.
Example:
CONFIG?
4.2.2 Stop Command
The STOP command immediately terminates all tuner movements.
Syntax:
STOP
Parameter:
None
Return value:
Always 0
Remarks:
Use the STOP command to immediately terminate all movements of the tuner.
The tuner stops generating pulses for the stepper motor, and de-energizes the
motor coils.