Focus Microwaves ituner - 4.2.3 Reset Command

iTuner Manual
17
Firmware revision below Rev2.0.35:
The tuner will be in a undefined state after the STOP command. You must call
the RESET or the INIT command before sending any further movement
commands.
Examples:
STOP
4.2.3 Reset Command
Call RESET to clear all calibration data, adapter and termination definitions
Syntax:
RESET
Parameter:
None
Return value:
Always 0
Remarks:
The RESET command performs the following tasks:
 Configures and initializes the motor control ICs
 Initializes all axis of the tuner
 Resets all calibration, adapater and termination data to default
Use the INIT? Command to monitor completion of the axis initialization
Examples:
RESET
4.2.4 Disp Command
Use the DISP command to show a message on the display of the tuner.
Syntax:
DISP message
Parameter:
message
Message to be displayed.
Use ‘|’ character to write to second line
Return value:
Always 0
Remarks:
The tuner does write to the display during initial start-up, each time TCP/IP
communication is established or closed and after every movement.
Examples:
Disp “line1|line2”