Focus Microwaves ituner - 4.3.1 Init Command

iTuner Manual
19
3 -> vertical motor (low frequency)
4 -> harmonic probe
PMT
4
1 -> horizontal motor (tuning section)
2 -> vertical motor (tuning section)
3 -> horizontal motor (pre-match section)
4 -> vertical motor (pre-match section)
PHT
2
1 -> 3
rd
harmonic probe
2 -> 2
nd
harmonic probe
MPT
3
1 -> horizontal motor (probe 1)
2 -> vertical motor (probe 1)
3 -> horizontal motor (probe 2)
4 -> vertical motor (probe 2)
5 -> horizontal motor (probe 3)
6 -> vertical motor (probe 3)
MPT-2C
6
1 -> horizontal motor (carriage 1)
2 -> vertical motor (carriage 1 , high
frequency)
3 -> horizontal motor (carriage 2)
4 -> vertical motor (carriage 2, high
frequency)
5 -> horizontal motor (carriage 3)
6 -> vertical motor (carriage 3, high
frequency)
7 -> vertical motor (carriage 1 , low
frequency)
8 -> vertical motor (carriage 2 , low
frequency)
9 -> vertical motor (carriage 3 , low
frequency)
The tuner type is factory defined, and all configuration data are stored on the internal EEPROM
of the tuner. The config? command (see 4.2.1) is used to display the configuration data.
4.3.1 Init Command
Call Init to initialize all or selected axis of the tuner to its home position