Focus Microwaves ituner - 4.6 Configuration and Maintenance Commands

iTuner Manual
42
of VSWR_STEP command to position the VSWR phase anywhere on the VSWR
circle, relative to the VSWR_INIT phase.
Examples:
VSWR_PHASE 45
Set VSWR phase 45degr off from VSWR_INIT phase
4.6 Configuration and Maintenance Commands
These commands are used to do various maintenance and configuration tasks such as manage
the calibration data, set IP address, and retrieve the tuner configuration data.
4.6.1 Watchdog command
Syntax:
Watchdog ON|OFF|TEST
Parameter:
ON | OFF | TEST
See description below
Return value:
Remarks:
Examples:
Watchdog ON
4.6.2 ERASE_CAL command
Erase the calibration data corresponding to the specified ID, where calID is the identifier
returned by DIR
4.6.3 Compact command
Defragments the iTuner’s onboard file system
4.6.4 Format command
Erases all calibration data stored on the flash memory card of the Tuner. This command takes a
long time to execute.