Electroniclevelcontrol starts automaticallyifthe
ignition is switched on. Operation is only possible
afterthe parking brakehas been applied.
Electronic levelcontrol performsaself-checkreg‐
ularly when it is activated and while in use. Indi‐
cator lamp 7 on theremote control lights up for
about one second when youswitch on theigni‐
tion.
Thereisamalfunction if indicator lamp 7
behavesinthe following ways:
R
The indicator lampdoes notlight up when you
switchonthe ignition.
or
R
The indicator lampthen lights up again or
flashes.
In addition,awarning tone is emitted from the
remote control forapproximately 30 seconds.
Thefault that has been detected can be shown
using theindicator lamps (signaling of fault
codes).
#
Park thevehicle, leaving theignition switched
on.
#
Applythe parking brake.
#
To raise or lowerthe vehiclelevel: press
and hold button 4 or 5 until thevehicle
levelreaches therequired height.
The indicator lampinbutton 4 or 5 flashes
as longasthe vehicle levelisbeing changed.
When thevehicle levelhas been set, theindi‐
cator lampinbutton 4 or 5 lights up.
#
To lowerautomatically: brieflypress button
5.
Electroniclevelcontrol automaticallylowers
thevehicle to thenextlower position:
R
From thehighestposition to driving level
R
From driving leveltothe lowest position
The indicator lampinbutton 5 flashes as
longasthe vehicle levelisbeing changed.
When thevehicle levelhas been set, theindi‐
cator lampinbutton 5 lights up.
%
By pressing button 4 during themovement,
theoriginal position will be reset.
#
To raise automatically: briefly press button
4.
Electronic levelcontrol automaticallyraises
thevehicle to thenexthigher position:
R
From thelowest position to driving level
R
From driving leveltothe highestposition
The indicator lampinbutton 4 flashes as
longasthe vehicle levelisbeing changed.
When thevehicle levelhas been set, theindi‐
cator lampinbutton 4 lights up.
%
By pressing button 5 during themovement,
theoriginal position will be reset.
#
To raise or lowerautomatically to driving
level(center position): press and hold but‐
ton 6.
Electroniclevelcontrol automaticallyraises or
lowers thevehicle to driving level.
#
To save theset vehiclelevel: setthe
required vehicle level.
#
Press and hold button 1 or 2 until youhear
atone.
The vehicle levelset has been savedoncorre‐
sponding button 1 or 2.
#
To call up thesavedvehicle level: briefly
press button 1 or 2.
Electronic levelcontrol automaticallyraises or
lowers thevehicle to thesaveddriving level.
The indicator lampinbutton 1 or 2 flashes
as longasthe vehicle levelisbeing changed.
When thevehicle levelhas been set, theindi‐
cator lampinbutton 1 or 2 lights up.
%
Service mode mayonlybeactivated or deac‐
tivated at aqualified specialistworkshop by
trained personnel. In service mode, theair
suspension system is deactivated formainte‐
nance or fault detection.
#
To activateservicemode: press button 3.
Service mode is activeand theindicator lamp
in button 3 lights up continuously.
#
To deactivateservicemode: press button
3.
Service mode is deactivated and theindicator
lampinbutton 3 goes out.
Driving and parking
127
To Next Page
Loading...
