This can cause youorother people to
become trapped.
#
Beforedriving, alwaysclose theparti‐
tion sliding door and ensurethat it is
engaged.
#
To open: turnthe keycounter-clockwise 3.
The sliding door is unlocked.
#
Slide thesliding door to theright 2 as faras
it willgo.
#
To close: slide thesliding door to theleft 1
until it engages.
Youcan lockthe sliding door withthe key.
Opening and closing thepartition slidingdoor
from thecargo compartment
#
To open: push thelevertothe right 3.
The sliding door is unlocked.
#
Slide thesliding door to theleft 1 as faras
it willgo.
#
To close: slide thesliding door to theright
2 until it engages.
Electrical step
Function of theelectrical step
Your vehicle's sliding door maybeequipped with
an electrical step.
Electrical step 1 automaticallyextends when
thesliding door opens, and retracts afterthe slid‐
ing door closes. Electrical step 1 is equipped
withobstacle detection at thefront.Ifthe step
meets an obstacle while extending, it stops. Once
youhave removedthe obstacle, youmustfirst
closethe sliding door then re-openitsothat the
step extends completely.
If theelectrical step prevents loading,you can
blockitvia obstacle detection whenthe sliding
door opens. The electrical step then remains
retracted and afork-lift truckorother lifting vehi‐
cle can move closer to thecargo compartment.
%
The displayshows the Step Not Extended
See Operator's Manual messageorthe step
not extended malfunction message.
When theignition is switched off, awarning
tone will sound if obstacle detection is
blocked. The tone lastsfor twominutes.
When theignition is switched on, thewarning
tone will sound continuously.
Vehicles with an instrument display(color
display): if thedisplayshows the Step Not
Retracted See Operator's Manual messageor
Step Not Extended See Operator's Manual mes‐
sageand awarning tone sounds, electricalstep
1 is malfunctioning (/ page279).
If electrical step 1 is malfunctioning, thestep
maynot extend or retract, or do so only partially.
54
Opening and closing
To Next Page
Loading...
