#
To move therackrails: unscrew star knobs
7 counter-clockwise until they areslightly
loose.
#
Sliderackrail 2 along roof rail 1 to the
desired position.
#
Screw star knobs 7 tight clockwise.
#
Checkthat therackrail is seated securely.
Moving thesliders
&
WARNING Risk of injury due to inade‐
quatelysecured loads
If theslider of theinterior roof rack system is
notengaged properly,the load maycome
loose, fall down and injurepeople, for
instance when they enter or load and unload
thecargo compartment.
#
Alwaysengagethe slider properly.
%
Ring 8 of slider 4 mustalwaysbeatan
angle of 90° to rack rail 2,sothat slider 4
is engaged properly.
#
When thering of theslider is at an angle
of 90° to therackrail: pullring 8 of slider
4 down andsimultaneously move slider 4
to thedesired position.
#
Release ring 8 at thedesired position.
#
Move slider 4 slightlyfurther along on rack
rail 2 until slider 4 engages automatically.
#
When thering of theslider is parallel to
therackrail: move slider 4 to thedesired
position.
#
Position ring 8 of slider 4 at an angle of
90° to rack rail 2.
Slider 4 is engaged.
Adjustingthe belt strap
#
Press and hold thelocking mechanism on
slider 9.
#
Pull or release belt strap 5.
#
Release thelocking mechanism on slider 9.
%
When securing or loosening aload, be sure
to notstand underthe load.
Securing and loosening theload
#
To securethe load: place theload in thebelt
straps of therackrails.
#
Fasten theload flush withthe partition.
#
Securebelt strap 5.
#
Checkthat theload is seated securely.
#
To loosen theload: press and hold thelock‐
ing mechanism on slider 9.
#
Pull ring 8 of theslider down and simultane‐
ously move theslider away from theload.
#
Loosen belt strap 5 and at thesame time
makesurethat theload does notfall out of
thebelt straps.
#
Remove theload from thebelt straps.
Installing cargo tie down rings
180
Transporting
To Next Page
Loading...
