Complywiththe country-specific regulations for
usingthe rear foglamp.
Operating thecombination light switch
1
High beam
2
Right turnsignal light
3
Headlampflashing
4
Leftturnsignal light
#
To indicate: push thecombination switchin
therequired direction 2 or 4 until it
engages. In thecase of larger steering move‐
ments, thecombination switchwill automati‐
cally switchback.
#
To indicatebriefly: tapthe combination
switchbriefly in therequired direction 2 or
4.The corresponding turnsignal lampwill
flash threetimes.
#
To switchonthe highbeam: switch on the
lowbeam (/ page81).
#
Pushthe combination switchforwards 1.
The K indicator lamponthe instrument
clusterwilllightup. The combination switch
willreturntoits startingposition.
%
The high beam switches to the à position
onlyindarkness and when theengine is run‐
ning.
#
To switchoff thehigh beam: push thecom‐
bination switchforwards 1 or briefly pull it
in thedirection of arrow 3 (the actionfor
headlampflashing switches thehigh beam
off).
The K indicator lamponthe instrument
clusterwillgoout. The combination switch
willreturntoits startingposition.
%
Vehicles with Highbeam Assist: when
Highbeam Assistisactive, it controls the
activationand deactivationofthe high beam
(/ page83).
#
To activateheadlampflashing: switchon
thepowersupply or ignition.
#
Briefly pull thecombination switchinthe
direction of arrow 3.
Switching hazardwarninglights on or off
#
To switchonand off: press button 1.
If youoperateaturnsignal indicator while the
hazardwarning lightsare switched on, onlythe
turnsignallamps on therelevant sideofthe vehi‐
cle will light up.
%
The hazardwarning lightswill work even
when thevehicle has been switched off.
Cornering light function
The cornering light improvesthe illuminationof
theroadway overawideangle in theturning
direction,e.g. enabling better visibility in tight
bends.
82
Light and vision
To Next Page
Loading...
