Friendly Robotics robomower RL800 - 5.3.2 Edge Calibration

5.3.2 Edge Calibration
Edge Calibration determines the position of the Robomow relative to the wire in edge mode.
A. Verify that the perimeter switch/docking board switch is on.
B. There are two options to perform the Edge Calibration:
1. If the wire is visible, position the Robomow over a perimeter wire. The Robomow
should be positioned on the wire facing in a counter-clockwise position when viewed
from the inside of the perimeter. Cutting height and ground clearance should be set to
the middle position. The wire should be centered relative to the unit, and the unit should
be at least 3m (10 ft) away from the nearest corner of the perimeter (See Figure A
below).
2. If the wire is not visible, position the Robomow inside the lawn, perpendicular to a
section of straight perimeter wire and at least 3m (10 ft) from a corner (See Figure B
below).
Figure A Figure B
about 1m (3 ft)
at least 3m (10 ft) at least 3m (10 ft)
at least 3m 10 ft
at least 3m (10 ft)
C. Select Edge Calibration in the ‘Service’ menu.
D. Complete Edge Calibration as described below:
You will see a series of
numbers quickly
changing – wait until
the final score is
dis
p
la
y
ed
Press the GO button
Edge Calibration
132 Done
Edge Calibration
Press GO
At the end of the calibration
a score will be displayed.
(This score is an example only)
5
6