5.7 Last Stop Cause
Every time the mower stops with an error message (+ Press GO), it is possible to look at the
‘Last stop cause’ information under the ‘Information’ menu and to have more details about
the reason, which cause the mower to stop.
The table below shows the description of the stop cause:
Stop
cause #
Message
Description
1 Internal use
2 Blocked path Bumper event was received during GO sequence
3 Start elsewhere Software problem – bumper related
4 Start elsewhere Software problem – bumper related
5 Start elsewhere Software problem – bumper related
6 Start elsewhere Software problem – bumper related
7 Drive overload Drive motor overload
8 Low battery Very low battery voltage
9 Start elsewhere Software problem
10 Drive problem
Problem in the odometer (drive wheels are active but odometer
pulses are not detected)
11 Drive overload Drive motor overload
11 (only
in 2005
version)
Start elsewhere
Time out during forward or backward movements during scanning
(The robot is probably stuck)
12 Front wheel prob.
Robomow has exceeded the allowed front wheel detection time
(Drop off)
13 D.K. problem DK problem
14 Start elsewhere
DK current calibration failure
(During the mowing motors activation in the GO sequence)
15 Start elsewhere Software problem
16 Start elsewhere Software problem
17 Start elsewhere Software problem
18 Start elsewhere Software problem
19 Start elsewhere
Time out during forward or backward movements during scanning
(The robot is probably stuck)
20 No wire signal
Mechanism for recovering from electricity power interruption
during automatic operation has failed
21 Mowing overload
Mechanism for recovering from mowing motors overheat during
automatic operation has failed
22 Front wheel prob.
Robomow has exceeded the allowed front wheel detection time
(Drop off)
5
28
To Next Page
Loading...
