Stop
cause #
Message
Description
23 Start elsewhere
Problem with the wire during Edge
Robomow has detected that all 4 wire sensors are outside the
garden for too long
24 Start elsewhere Problem with the wire during Edge
25 Start elsewhere
Problem with the wire during Edge
Robomow unable to locate the wire for too long
26 Start elsewhere Failure of the Wire Acquisition process
27 Start elsewhere Software problem
28 Start elsewhere
Failure of the Wire Acquisition process - rear bumper was
detected during Acquisition
29 Max dist reached
Robomow has reached the maximal Edge distance during the
“Learn Edge" process
30 Docking problem
Edge process was terminated before we reached the docking
station
31 Start elsewhere Software problem
32 Start elsewhere Software problem
33 Drive overload
Mechanism for recovering from drive motors overheat during
automatic operation has failed
34 Check mow height
Mowing motors problem
Mowing motors are off but high currents are measured. This
means that either the mowing motors or the Main board are
damaged.
36 Check mow height
Mowing motors problem
High Mowing motors currents are detected after Mowing currents
calibration in GO (after mowing motors are activated for a few
seconds when robot is not moving).
37 Start elsewhere Software problem
38 Start elsewhere Software problem
39 Start elsewhere Software problem
40 Check mow height
Mowing motors problem
Too many over current events occurred during automatic mode.
41 Start elsewhere Software problem
42 Start elsewhere Software problem
43 Check mow height
Mowing motors problem
Over current event during manual mode
44 Start elsewhere Software problem
45 Docking problem Failure connecting to the docking station
46 Start elsewhere Software problem
47 Start elsewhere Software problem
48 Start elsewhere Software problem
5
29
To Next Page
Loading...
