Stop
cause #
Message
Description
128 Max dist reached
Robomow has reached the maximal Edge distance during the
“Wire position test"
129 Test result: ‘result’ Termination of the Edge termination test
130 Test result: ‘result’ Termination of the docking station entry test
131 Docking problem
Robomow has slid off the docking station more than 5 times
during the current charging process
132 Docking problem
Robomow has slid off the docking station more than 5 times
during the current charging process
134 Low temperature
Ambient temperature is too low for more than 12 hours during the
charging process
135 High temperature
Ambient temperature is too high for more than 12 hours during the
charging process
136 Charging failure Charging problem
137 Charging failure
Charging FET temperature is too high for more than 3 hours
during the charging process
138 Check P. switch Perimeter switch problem
139 Check Power
No wire or charger voltage are detected in the docking station for
more than 1 minute
140 Check Power Charging problem
141 STOP button was pressed during automatic operation
142 Remote was taken out during automatic operation
143
Left/Mid/Right mow
problem
Disconnected or burnt Left Right or Middle mowing motor
144 Start elsewhere
Robot stuck monitor detection.
Robot is stuck in place for too long.
145
One of the
following:
No wire signal
Mowing overload
Drive overload
Auto restart mechanism stop.
5
32
To Next Page
Loading...
