Friendly Robotics robomower RL800 - Page 60

3
5
Problem analysis flow charts – Table of Contents
3.2.1 Installation and Setup
7
3.2.1.1 Wire disc (P. Switch)
7
3.2.1.2 Replace battery (P. Switch)
9
3.2.1.3 P. Switch does not operate
10
3.2.2 Power & Charging
11
3.2.2.1 Robomower does not 'Wake up'
11
3.2.2.2 Charging Failure
12
3.2.2.3 Check Power
13
3.2.2.4 No Charging indication
14
3.2.2.5 Short run time
15
3.2.3 Mowing
16
3.2.3.1 ‘Check mow height’ message
16
3.2.3.2 Uncut lane left behind the Robomower
16
3.2.3.3 Mowing motors do not start but the Robomower moves on the lawn
16
3.2.3.4 ‘Mow overload – Cooling, wait…’ message
16
3.2.3.5 Cannot start mowing motors in manual mode
17
3.2.3.6 Poor mulching
17
3.2.4 Edge
18
3.2.4.1 Does not complete Edge
18
3.2.4.2 Robomower is not centered on the perimeter wire
19
3.2.4.3 Robomower is ‘zigzagging’ as it edges (weaves left and right)
19
3.2.5 Automatic Mowing
20
3.2.5.1 Many patches of uncut grass remain on the lawn
20
3.2.5.2 Robomower ignores areas
20
3.2.5.3 Stops with no message
21
3.2.5.4 Robomower keeps going back and forth on the same lines
22
3.2.5.5 Poor direction keeping – Robomower does not move in straight lines
22
3.2.5.6 Wire crossing
23
3.2.6 Manual Controller
24
3.2.6.1 One or more of the Manual Controller buttons do not respond
24
3.2.6.2 Manual Controller display does not change to ‘Zone A’ / ‘Dock zone’
when placing it in its place.
24
3.2.7 Drive
25
3.2.7.1 ‘Drive overload – press GO’ message
25
3.2.7.2 ‘Drive overload – Cooling, wait…’ message
25
3.2.7.3 ‘Drive Problem’ message
26
3.2.8 Front Wheel
27
3.2.8.1 ‘Front wheel problem’ message
27
3.2.9 Bumpers
28
3.2.9.1 ‘Front /Rear Bumper Pressed’ message
28
3.2.9.2 ‘Front /Rear Bumper disc.’ message
29
3.2.9.3 Bumper sounds without hitting an obstacle
29
3.2.9.4 Bumper is not responding when hitting an obstacle
30