Friendly Robotics robomower RL800 - Page 76

3
3.2.5 Automatic Mowing Problems (con.)
21
Robomow had
stopped and is
found with no erro
r
message
Manual
User Option
Zone A /
Dock zone
What was
the display
in the LCD?
The display is turned off
automatically after 20 min.
Remove the Manual
Controller from its place or
press the GO button to see
the last messa
g
e dis
p
la
y
ed
Y
ES
NO
Make sure that prior to
inserting the Manual
Controller to its place,
the cord is stored well
underneath.
Y
ES
NO
Confirm the Manual Controller
is placed well and flushed with
the Top Cover – short liftin
g
of
the Manual Controller while
operating will cause the mower
to stop.
Robomower is like a computer
– in very rare cases it may
shutdown automaticall
y
(
reset
)
 Confirm The Manual Controller
is placed well and flushed with
the Top Cover.
 Confirm Power Pack contacts on
both sides (bat. and RL) are not
loose/damaged.
 Remove Connectors Board
cover and confirm the fuses are
not free to move and there is
no corrosion on the fuse
housing.
 Confirm good contact between
M. Controller cord plug and
socket on the Connector Board.
 Remove Power Pack cover and
check for loose connections
Blank
LCD
Is it a
recurring
problem?
Replace the M. Controller
with a
g
ood one and view
the display to see if it
changes to Auto menu
when it is flushed with the
Top Cover
Is the M.
Controller in its
place (flushed
with the Top
Co
v
e
r
su
rf
ace)
?
A magnet is located
underneath the
rectangular
protrusion. Its
function is to chan
g
e
between the Manual
and the Auto modes
Remove the Top
cover – confirm
there is a ma
g
net
inside the cover
The Manual
Controller is
faulty -
Replace
NO
Y
ES
Is it
changed?
If the Manual Controller
cord is misplaced in the
cavity it may push the
Manual Controller durin
g
operation and stop the
automatic operation
3.2.5.3