What to do if the POWER light does not light up on my Fritsch ANALYSETTE 3 Laboratory Equipment?
If the POWER light on your Fritsch Laboratory Equipment isn't lighting up, here's what you can check: * Ensure the mains plug is properly connected. * Verify that the main switch is turned on. * Inspect and replace the mains fuse if it's blown. * Check the line fuse of the mains socket and switch it on or replace the fuse in the fuse box.
Why is the sieving stock not dispersed evenly on the sieve surface in my Fritsch ANALYSETTE 3 Laboratory Equipment?
Uneven dispersion of sieving stock on the sieve surface of your Fritsch Laboratory Equipment can occur due to: * Unevenly tightened toothed belt: Ensure the toothed belt is tightened evenly. * The device not being level: Level the device by adjusting the feet. * Old sieves with deformed mesh wire: Replace the sieve if the mesh wire has no tension.
What to do if I observe large control fluctuations around the set point in my Fritsch Laboratory Equipment?
Large control fluctuations around the set point in your Fritsch Laboratory Equipment can be caused by: * A loose sieve stack: Tighten the toothed belt. * Loose screws on the laminated spring assembly: Re-tighten the screws to 8Nm. * Defective flat springs: Check the flat springs for tears and replace the laminated spring assembly if needed. * Overheated flat springs: Allow the springs to cool down.
How to fix rattling noises in Fritsch ANALYSETTE 3?
Rattling noises in your Fritsch Laboratory Equipment may be due to: * A loose tension belt: Tighten the tension belt. * An amplitude exceeding 3 mm: Set the amplitude to less than 3 mm.
Defines who can operate and maintain the ANALYSETTE 3, emphasizing trained personnel.
Explains the electromagnet and vibratory system of the ANALYSETTE 3.
Highlights the importance of using and maintaining protective equipment.
Details general electrical safety, protection against restart, and overload protection.
Explains hazard symbols and safety information designations used in the manual.
Provides physical specifications like dimensions (350x200x400mm) and net weight (21kg).
Details operational voltage ranges (115V/230V) and power consumption (approx. 50W).
Lists applicable sieve mesh widths for dry, wet, and micro sieving.
Guidance on placing the device on a stable surface and leveling it.
Procedures for connecting the device to the power supply and adjusting mains voltage.
Steps to power on the device and verify its operational status.
Covers fitting sieves, clamping, and the general sieving procedure.
Details parameters, aids, and procedures for dry sieving.
Explains procedures, parameters, wetting agents, and precautions for wet sieving.
Instructions for using the ANALYSETTE 3 PRO for high-precision sieving.
Guides on setting sieving time, amplitude, interval time, and saving settings.
Information on the software for automatic evaluation of sieving results.
Details the TorqueMaster for faster and more accurate sieve clamping.
Instructions for cleaning the device and test sieves.
Covers the maintenance and cleaning of the TorqueMaster clamping unit.
A guide to identify and resolve common faults and issues with the device.
Outlines warranty terms, claims, and conditions that void the guarantee.
General| Sieve Height | up to 50 mm |
|---|---|
| Sieve Diameter | 200 mm / 8" |
| Timer | 1 - 99 min |
| Operating Mode | Continuous or interval operation |
| Voltage | 230 V, 50/60 Hz |
To Next Page