Fritsch ANALYSETTE 3 - Releasing the Torquemaster

CAUTION!
F
ollow the separate operang instrucons of the cord-
less screwdriver manufacturer. These are included with
the device.
When clamping, make sure to li the TorqueMaster
slightly (illustraon 1 + 2). If the toothed belt is not
slightly tensioned, it will be crushed in the Torque-
Master (illustraon 3 + 4).
7.4.3 Releasing the TorqueMaster
The T
orqueMaster clamping device is also released with the cordless
screwdriver.
The clamping unit is released far enough so that it can be placed behind
the device without changing the toothed belt clamp in the belt clamping
device.
The clamped toothed belts on the belt clamping device is only released
or adjusted, when the number or height of the sieves in the sieve stack
changes.
Accessories
- 37 -