Fronius Primo GEN24 208-240 User Manual

IMPORTANT!
Very high start-up currents can temporarily distort or interrupt the output
voltage. Simultaneous operation of electronic devices in the same backup power
grid should be avoided.
IMPORTANT!
The inverter may only be operated within the limits of its technical capabilities.
Operation outside of its technical capabilities can cause the inverter to shut
down.
Equipment
grounding (GND)
Grounding a point in the device, system, or installation serves as a protective
measure against electric shock in the event of a fault. When installing an inverter
from safety class 1 (see Technical data), a ground conductor connection is re-
quired.
When connecting the ground conductor, ensure that it is secured to prevent un-
intentional disconnection. All of the points listed in the chapter headed Con-
necting the inverter to the public grid (AC side) on page 49 must be observed.
When using strain-relief devices, it is important to ensure that the ground con-
ductor is loaded last in the event of a failure. The respective national standards
and regulations and requirements for minimum cross-section must be observed
when connecting the ground conductor.
9

Fronius Primo GEN24 208-240 Specifications

General

Type	Hybrid Inverter
AC voltage range	183 - 264 V
AC grid frequency	60 Hz
THD	< 3%
Max. input voltage	600 V
Number of DC connections	2
Number of MPP trackers	2
Max. battery charging / discharging current	22 A
Protection class	IP66
Model	Primo GEN24 208-240
Battery Compatibility	BYD Battery-Box Premium HVS/HVM
Communication Interfaces	Ethernet, RS485
Operating Temperature Range	-25°C to +60°C
Cooling	Active cooling
Warranty	5 years (extendable)