WARNING!
Danger from grid voltage and DC voltage from PV modules that are exposed to
light.
This can result in severe personal injury and damage to property.
▶
All connection, maintenance, and service work should only be carried out
when the AC and DC sides have been disconnected from the inverter and are
de-energized.
▶
Only an authorized electrical engineer is permitted to connect this equip-
ment to the public grid.
WARNING!
Danger from damaged and/or contaminated terminals.
This can result in severe personal injury and damage to property.
▶
Prior to connection work, check the terminals for damage and contamina-
tion.
▶
Remove any contamination while the equipment is de-energized.
▶
Have defective terminals replaced by an authorized specialist.
PV generator,
general
Two independent PV inputs (PV 1 and PV 2) are available. These inputs can be
connected to a number of different modules.
When starting for the first time, set up the PV generator in accordance with the
respective configuration (can also be carried out at a later date in the "System
configuration" menu field under menu item "Components").
Module array
configuration 7.7
‑ 10.0 kW
IMPORTANT!
The installation must be carried out in accordance with the nationally applicable
standards and directives.
Current equal to or less than 22 A (I
dcmax
).
Module array settings:
PV 1: ON
PV 2: OFF
IMPORTANT!
The maximum current load of a single
terminal is 22 A.
54
To Next Page
Loading...
