Attaching the
mounting brack-
et to mounting
rails
IMPORTANT!
The mounting bracket must be affixed
at a minimum of four points.
Attaching the in-
verter to the
mounting brack-
et
Integrated grips, which facilitate lift-
ing/clipping, are located on the side of
the inverter.
1
Clip the inverter into the mounting
bracket from above. The connections
must point downwards.
The lower area of the inverter is
pushed into the snap-in tabs until the
inverter engages on both sides with an
audible click.
Ensure the correct position of the in-
verter on both sides.
44
To Next Page
Loading...
