WARNING!
Danger from unsuitable batteries connected to the battery charger.
Serious personal injury and property damage as a result of escaping gases, ignition or
explosion may result.
▶
Only connect batteries to the battery charger which are suitable for the battery char-
ger in terms of their type, voltage and capacity and which correspond to the settings
on the battery charger.
The battery charger is designed for charging lead-acid batteries and NiCd batteries. Set
the battery charger to the type of battery to be charged:
- Pb-WET batteries (PzS, GiS, ...):
Venting, closed lead-acid wet batteries with liquid electrolyte.
- Pb-GEL batteries (PzV, GiV, ...):
Valve-regulated, sealed lead-acid batteries (VRLA) with fixed electrolyte (gel or
fleece).
- NiCd batteries:
Closed or sealed NiCd batteries with liquid electrolyte.
- Pb-CSM-WET batteries (Copper Strained Metal):
Closed lead-acid CSM batteries with liquid electrolyte.
- Lead Crystal batteries:
Type EVFJ/CNFJ Lead Crystal batteries.
The device must be handled correctly in order for it to work. Never pull on the cable
when handling the device.
Grid connection
WARNING!
Danger from electrical current.
This may result in serious injuries or death.
▶
Before starting work, switch off all devices and components involved, and discon-
nect them from the grid.
▶
Secure all devices and components involved so they cannot be switched back on.
▶
If necessary, only use a type B residual current circuit breaker for the grid connec-
tion of the device.
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in severe personal injury and damage to property.
▶
All the work and functions described in this document must only be carried out by
trained and qualified personnel.
▶
Read and understand this document.
▶
Read and understand all the Operating Instructions for the system components, es-
pecially the safety rules.
WARNING!
Danger due to faulty or insufficient grid power supply.
This can result in severe personal injury and damage to property.
▶
The requirements for the grid power supply according to the "Technical data"
chapter must be fulfilled.
12
To Next Page
Loading...
