71
EN
Rod electrode setup menu
Accessing the
Rod electrode
setup menu
Changing weld-
ing parameters
Exiting the Rod
electrode setup
menu
Welding parame-
ters in the Rod
electrode setup
menu
Press the Mode button to select the MMA welding mode
Press and hold the Mode button
Press the Parameter Selection button (right)
The power source is now in the Rod electrode setup menu. The last
welding parameter selected is displayed.
Use the left or right Parameter Selection button to select the param-
eter that you want to change
Use the adjusting dial to change the parameter value
1
2
Press the Mode button
1
HCU
HotStart current
Unit %
Setting range 0 - 200
Factory settings 150
Hti
Hot-current time
Unit s
Setting range 0.0 - 2.0
Factory settings 0.5
To obtain optimum welding results, it will sometimes be necessary to adjust the HotStart
function.
Benefits
- Improved ignition, even when using electrodes with poor ignition properties
- Better fusion of the base material in the start-up phase, meaning fewer cold-shut de-
fects
- Largely prevents slag inclusions
To Next Page
Loading...
Need help?
General
