66
TIG setup menu
Accessing the
TIG setup menu
Changing weld-
ing parameters
Exiting the TIG
setup menu
Welding parame-
ters in the TIG set-
up menu
Press the Mode button to select 2-step mode or 4-step mode
Press and hold the Mode button
Press the Parameter Selection button (right)
The power source is now in the TIG setup menu. The last welding pa-
rameter selected is displayed.
2
3
Use the left or right Parameter Selection button to select the param-
eter that you want to change
Use the adjusting dial to change the parameter value
1
2
Press the Mode button
1
SPt
Spot welding time
Unit s
Setting range OFF / 0.05 - 25.0
Factory settings OFF
If a value has been set for the SPt setup parameter, the operating mode 2-step mode will
have the function of the spot welding mode.
The special spot welding indicator on the control panel remains lit as long as a value has
been specified for the spot welding time.
tAC
Tacking function when TIG DC welding is selected: Duration of the pulsed welding current
at the start of tacking
Unit s
Setting range OFF / 0.1 - 9.9 / ON
To Next Page
Loading...
Need help?
General
