3-10
Function codes that require simultaneous keying
To change data for function codes F00 (Data Protection) and H03 (Data Initialization), simultaneous
keying operation is necessary-- + keys or + keys. This prevents data from being lost by
mistake.
Changing, validating, and saving of function code data during running
Some function code data can be changed while the motor is running and some cannot. Further, amongst
the function codes whose data can be changed while the motor is running, there are some for which the
changes can be validated immediately and others for which they cannot. Refer to the "Change when
running" column in Chapter 9, Section 9.1 "Function Code Tables."
To Next Page
Loading...
