5 Copy
134
[Edge Erase]
When you copy an original with the document cover open or when you copy a book, the
edges and center margin of the original may be printed as black shadows. The Edge Erase
feature allows you to erase such shadows.
For 2-sided originals, the same edge erase amounts are set for the front and back sides.
If you set [Reduce / Enlarge], the edge erase amounts will be reduced or enlarged in proportion to the ratio
you specified.
The binding shift specified in [Booklet Creation] will not affect the edge erase amounts.
If you use the document glass for the 2 sided original document, the setting for [Mirror Side 1] becomes
invalid. Use the document feeder or select [Build Job] to change the edge erase setting for side 1 and side 2
when using the original which the document feeder does not accept.
Even when the edge erase amount is set to 0 mm, full page copying cannot be made. For information on the
areas that can actually be printed, refer to "Printable Area" (P.478).
[Image Shift]
This feature allows you to shift the position of images on the original so that the images
are placed on the left, right, top, bottom, or center of paper. You can also adjust the
amounts of the left, right, top, and bottom margins. If you make 2-sided copies, you can
adjust the image positions for Image Shift and Side 2 individually.
The image shift amount is set in accordance with the paper, and does not affect the setting made in [Reduce
/ Enlarge].
[Mirror Image]
This feature allows you to reverse the left and right sides of the image on the original when
making copies.
[Negative Image]
This feature allows you to create a negative image copy of the original.
When [Output Color] is set to [Black & White] or [Single Color], the color density is inverted.
When [Output Color] is set to [Color], the colors are inverted to their complementary colors.
When [Negative Image] and [Edge Erase] are set simultaneously, the edge erase area turns to white.
[Image Rotation]
If the orientation of the paper currently loaded in the tray differs from that of the original
loaded, the device automatically rotates the image so that the orientation of the image
matches that of the paper. You can also select a reference position for image rotation if
originals are of mixed orientations.
This feature is available only when you make copies on A4, 8.5 x 11", or smaller size paper.
To Next Page
Loading...
Need help?
General
