13 Advanced Settings
254
[Display Reset Button]
Set whether or not to display the reset button on the top of each app screen.
[Security Warning (Admin)]
Set whether or not to display the security warning screen when the default values of system
administrator's user ID and password are used. The warning screen is displayed when
entering the System Administration mode on the control panel or on the CentreWare
Internet Services.
[Security Warning (SNMP)]
Set whether or not to display the security warning screen when the default values of SNMP
protocol's community name and authentication password are used. The warning screen is
displayed when entering the System Administration mode on the control panel or on the
CentreWare Internet Services.
You can set the SNMP protocol settings on CentreWare Internet Services. For more information, refer to the
help of CentreWare Internet Services.
[Security Warning (Global IP)]
Set whether or not to display the security warning screen when the Global IP Address is
used and [Login Type] is set to [No Login Required]. The warning screen is displayed when
entering the System Administration mode on the control panel or on the CentreWare
Internet Services.
[Confirm Settings When App Starts]
Set whether or not to display the screen to ask if to take over the previous settings when
you open each app on the Home screen.
[Suppress Notification Banner]
If a check mark is placed, event notifications (messages notifying maintenance and
warning) are hidden.
[Message Banner Display Time]
Select how long time to display the messages.
[Job Confirmation Banner Display Settings]
Set whether to display the message regarding the processing job after the Auto Clear.
[Run Status Display Format]
Set whether to display a screen or a message that indicates that the job is processing after
submitting the job.
[Image Quality]
You can select the image quality processing method when the device scans a document.
[Photo & Text Recognition]
Allows you to change a level with which the device determines a document as text or
photos. This setting is used when you select [Photo & Text] for [Original Type].
To Next Page
Loading...
Need help?
General
