[System Settings]
251
[Sleep Mode Settings]
Set whether the top priority of Sleep mode is power saving or wake up time.
Even when [Prioritize Power Saver] is set, the device may operate as if [Prioritize Wake Up Time] was set
depending on the configuration and settings of the device.
[Power Saver Deactivation]
Select whether to disable the Power Saver mode fully or partially when exiting the mode.
[Scheduled Power Off]
Sets the power to turn off automatically at the specified time.
Even when [Enabled] is set, the device will not be automatically turned off during an error (such as paper jam)
or processing jobs.
[Audio Tones]
Select whether to sound an alarm when a job ends or a fault occurs.
[Tone Type]
Select [Standard] or [Beep].
[Control Panel Select Tone]
Set the volume to be sounded when a button on the control panel is correctly tapped.
[Control Panel Alert Tone]
Set the volume to be sounded when an unavailable button is tapped, or an error occurs.
[Device Ready Tone]
Sets the volume of the sound to indicate that the device is ready, such as when power is
turned on.
[Job Complete Tone]
Set the volume to be sounded when a job is completed normally.
You can set whether to play the sound per each job type.
[Fax Received Tone (Line 1)]
Set the volume to be sounded when a fax receiving job such as Print Fax and Store File -
Local Folder is completed normally.
[Fault Tone]
Set the volume to be sounded when a job fails.
You can set whether to play the sound per each job type.
[Auto Clear Alert Tone]
Set the volume to be sounded at five seconds before automatically returning to the initial
screen when [Auto Clear] is set to [On].
For information on Auto Clear, refer to "[Auto Clear]" (P.249).
To Next Page
Loading...
