Fuji Xerox ApeosPort-VII C4421 - [Internet Fax Settings]

[App Settings]
289
 [G3 Line 1 - Fax ID]
When using G3 communications, register the G3 ID. The G3 ID is normally set to the local
terminal fax number.
 [G3 Line 1 - Dial Type]
Set the dial type.
 [G3 Line 1 Transmission]
Set the transmission method.
Note

Usually there is no need to change the default settings.
The factory default depends on your country. If a communication error occurs with [Detect Tone], for example
when you use PBX, select [Do Not Detect Tone].
 [Detect Tone]
Set for fax transmissions on a standard phone line.
 [Do Not Detect Tone]
Set for fax transmission performed without detecting dial tone.
[Add Fax Comment]
You can register comments to be printed on cover sheets.
[Internet Fax Settings]
[Screen Defaults]
 [Transmission Screen]
Set whether or not to display the status screen during a transmission.
[Fax Control]
 [Re-enter Recipient]
Set whether to re-enter the recipient after once specifying the recipient to reduce the risk of
sending an Internet fax to the wrong address. When set to [Enter Twice] and you specify
the recipient by entering the phone number, the screen prompting you to re-enter the
recipient appears. If the same recipient has been entered, the transmission process will
start.
 [Re-enter Broadcast Recipients]
This setting is required when you selected [Enter Twice] for [Re-enter Recipient]. Set
whether or not to allow the Broadcast Send.
 [Re-enter Contacts]
When you select [Enter Twice] for [Re-enter Recipient], set whether or not to display the
confirmation screen of specified address selected from the Address Book.
 [Re-enter Group Recipients]
When you select [Enter Twice] for [Re-enter Recipient], set whether or not to display
permission of specifying the group recipient and the confirmation screen.