6 Fax
152
[Forced 4800 bps]
Select this mode when transmitting over noisy or poor telephone lines, as can be the case
with overseas calls.
Also select this mode when transmitting over noisy or poor telephone lines domestically.
If you select [Forced 4800 bps], the transmission time may be longer because transmission is performed at
4,800 bps or less to ensure transmission is successful.
Here is the case of the area you can directly dial the remote device.
1
Enter the recipient fax number in the same manner as when you make an international call.
The following is an example:
In some areas, you may need to enter a pause after the telephone company ID number.
For information on the telephone company ID number, contact your telephone company.
2
Select [Starting Rate].
3
Select [Forced 4800 bps].
[Mixed Size Originals]
Scans originals of the same width but different length at a time and sends them to each
size paper. To use this feature, load the originals on the document feeder.
Align the both right and left edges of the originals to avoid a paper jam.
Be sure to set [Original Size] to [Auto Detect], when using the Mixed Size Originals feature.
[Transmission Header]
The Transmission Header Text feature adds the start time, sender name, recipient name,
transmission header, G3 ID, and the number of pages onto the scanned document when
sending a fax. You can also display the preview to confirm the position of the transmission
header text.
Since the Transmission Header overwrites the leading edge of the original data, the information at the
leading edge of the scanned document may be lost by about 3 to 5 mm.
Telephone
company ID
Country
code
Area code
Fax number of the
other party
To Next Page
Loading...
Need help?
General
