Manually Start a Job Flow by Selecting a Job Flow Created using the Device Setup Tool
201
Manually Start a Job Flow by Selecting a Job Flow
Created using the Device Setup Tool
This section describes job flow sheets targeting scanned documents.
1
Load an original.
A job flow with an application linked does not require you to load an original.
2
Tap [Job Flow Sheets] on the Home screen.
3
Tap [Select Job Flow Sheet].
4
Tap the job flow you want to use.
5
Tap [OK].
6
When you want to change the job flow settings temporarily, perform the following
operation.
1) Tap [Change Settings] and change the required settings.
2) When you finish setting, tap [OK].
[Change Settings] is displayed when you select a job flow whose settings can be changed.
7
Tap [Start] to execute the job flow sheet.
To Next Page
Loading...
