13 Advanced Settings
284
[Polling / Storage for Remote Devices]
Set whether or not to allow the following features:
Store for Polling
Send File for Free Polling
Store Fax - Local Folder
[Rotate 90 degrees]
Set whether or not to automatically rotate a document if its image must be reduced in size
unless it is rotated.
If an arbitrary magnification is specified in [Reduce / Enlarge], the Rotate 90 Degrees feature does not
function.
[G3 Sender ID - Fax]
When using G3 communications, you can select whether to notify G3 ID to recipients for
fax.
[Save Unsent Faxes]
Set whether or not to save a fax document if a fax transmission fails. If a check mark is put,
you can view [Unsent Faxes] by tapping on the [Jobs] screen. On the [Unsent Faxes]
screen, you can select jobs to retry.
For information on how to retry or delete undelivered faxes, refer to "Resending/Deleting Undelivered Faxes"
(P.162).
[Save Deleted Faxes]
When you put a check mark for [Save Unsent Faxes], set whether or not to save cancelled
faxes.
[Saved Faxes - Auto Delete]
When you put a check mark for [Save Unsent Faxes], set whether or not to automatically
delete saved faxes in 24 hours.
[Transmission Interval]
Specify a value for the interval between the end of one transmission and the beginning of
the next.
A longer transmission interval increases the total time to send a broadcast transmission,
but allows calls to be received during the standby time.
[Batch Send]
When the device stores multiple faxes addressed to a destination, enabling the Batch Send
feature allows you to send them all at the same time in a single fax transmission. By using
this feature, you can reduce your communication costs. Select whether or not to enable the
Batch Send feature.
Note that a batch send is not available for manual transmissions, broadcasts, remote
folder, and delayed start transmission with a specified time before the specified time.
When a redial, resend, delayed start transmission job, or the Authentication feature is used
and different users send to the same address, a batch send is not possible.
To Next Page
Loading...
