Fuji Xerox ApeosPort-VII C4421

13 Advanced Settings
320

[Destination IPv4 Address]
Set the IPv4 address or area of the destination permitted to communicate.

[Destination IPv6 Address]
Set the IPv6 address or area of the destination permitted to communicate.

[Communicate with Non-IPsec Devices]
Select whether or not to communicate with non-IPsec devices with an address other than
the ones set in the destination address.
[IEEE 802.1X Settings]
 [IEEE 802.1X Settings] / [IEEE 802.1X Settings (Ethernet 1)]

[IEEE 802.1X]
Set whether or not to use IEEE 802.1X authentication.

[Authentication Method]
Set the authentication method for IEEE 802.1x.

[Login User Name]
Enter the login user name with up to 128 characters.

[Login Password]
Enter the login password with up to 128 characters.

[Server Certificate Verification]
Select whether or not to verify a server certificate when [PEAP / MS-CHAPv2] is selected
in [Authentication Method].
[Certificate Revocation Settings]
Configure the settings for certificate revocation retrieval.
 [Level of Certificate Verification]
Select a level of certificate verification.
Selecting [Low] does not verify the validity of certificates.
Selecting [Medium] verifies the validity of certificates. If a certificate cannot be verified
because of a network error or any other problems, the certificate is determined as valid.
Selecting [High] verifies the validity of certificates, and determines only certificates that
have not been revoked as valid.
 [Retrieval of Certificate Status]
Select the method to verify the validity of certificates.
Select [By Retrieving CRL] if the device retrieves a CRL (Certificate Revocation List) from the
validation authority to verify the revocation status of the certificate. Select [By OCSP] if the
device uses OCSP (Online Certificate Status Protocol), which can verify the validity
revocation status of the certificate, to have the certificate authority or validation authority
check the revocation status.
 [Auto Retrieval of CRL]
Select whether or not to automatically retrieve a CRL.
 [CRL Retrieval Timeout]
Specify a time-out value to retrieve a CRL.