13 Advanced Settings
332
[Save Remote Accounts in This Device]
Select whether or not to save the user information used for remote authentication. While
the user information is saved in the device, the device can authenticate the user using the
information saved in the device even when the remote server is off.
This setting applies only to a user who is authenticated by smart cards.
The user authenticated by using the information saved in the device is set to [(Remote Authorization Groups
As Saved In This Device)].
[Delete Remote Accounts]
Select whether or not to delete the user information saved in the device for remote
authentication.
This setting applies only to a user who is authenticated by smart cards.
[Invalid Login Settings]
This feature prevents unintended operation by other users. If authentication for a same
user ID fails more than specified times continuously, access is denied.
Select [Enabled] for [Maximum Login Attempts - Administrator] or [Maximum Login
Attempts - Local User] and enter the maximum number of attempts allowed in [Maximum].
The failure count is reset when the device is restarted.
To cancel the access rejection state, restart the device by switching off and on the power.
For users other than the system administrator, this feature is available when [Login Type] is set to [Log In to
Local Accounts].
[Password Policy]
[Password for Control Panel Login]
You can set whether a password is required when a user uses the device.
Selecting [On] enables [Password] for [Create / View User Accounts].
Selecting [Off] does not require the password, even if a password is set in the above
settings.
The setting of [Password for Control Panel Login] is used for authentication using the control panel. A
password must always be entered when accessing from remote devices using CentreWare Internet Services
or the like, regardless of the use of password setting. Depending on authentication procedures, a password
may be required for other processes as well.
[Password for Smart Card Login]
You can set whether a password is required for smart card authentication when [Log In to
Local Accounts] is selected.
[Minimum Password Length]
Set this item when you specify the minimum number of digits allowed for registering a
password.
[Maximum Password Length]
Set this item when you specify the maximum number of digits allowed for registering a
password.
To Next Page
Loading...
Need help?
General
