Fuji Xerox ApeosPort-VII C4421

Scanner Environment Settings
59
Reference

For information on setting the TCP/IP address, refer to "Setting the IP address" (P.36).
 Enabling Port
1 Log in to the System Administration mode.
Reference

For more information, refer to "Login to Authentication Mode" (P.77).
2 Tap [Device] on the Home screen.
3 Enable the port.
1) Tap [Connectivity & Network Setup] > [Port Settings] > [WSD] > [Port (Scan to Desktop)].
2) Tap [Enabled].
4 Press the Home button.
Note

Rebooting the device is required to enable the settings. Reboot the device following the message on the
screen.