3 Copy
132
Copy
3
Z Fold Half Sheet
When the Finisher D4 with Booklet Maker (optional) is installed, the machine folds the
output copies in Z fold. Z fold can be applied to B4, A3, 11 x 17". If you have mixed
sized documents, the width (vertical direction) of the paper must be the same, such as
a combination of A4 (portrait) and A3 (landscape), and a combination of B5 (portrait)
and B4 (landscape). For example, if you have a combination of A4 (portrait) and A3
(landscape), the Z fold is only applied to A3.
Output Destination/Offset
Allows you to select the output destination tray and offset operation.
z
Offset Stacking
This option is not displayed when the Simple Catch Tray is installed.
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations.
You can select from [Offset per Set], [Offset per Job], [Offset Every N Pages], [Offset
Every N Sets], and [System Default] for a paper stack.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact your local Fuji Xerox representative.
Paper Size and Stapling Position
z
Finisher C2/Finisher C2 with Booklet Maker
* : The staple orientation displayed on the touch screen differs from the actual staple orientation. Outputs are stapled
in the orientation shown in the above table.
1 Staple
1 Top
Right
2 Staples 2 Top 2 Right
A4 , B5 ,
8 x 10" ,
8.5 x 11"
,
16K
A4, 8 x 10",
8.5 x 11",
8.5 x 13"
,
8.5 x 14"
A3, B4,
11 x 17", 8K
To Next Page
Loading...
Need help?
General
