Copy
83
Copy
3
îš„Auto Select
Automatically determines the tray holding the appropriate paper, based on the
document size and the specified copy ratio.
Note • If you select [Auto Select], an option other than [Auto %] is selected in [Reduce/Enlarge].
îš„Trays (2nd to 5th buttons)
Allows you to directly select the desired tray.
You can change the paper tray associated with each button on the [Copy] screen. For information on the
settings, refer to "5 Tools" > "Copy Service Settings" > "Preset Buttons" > "Paper Supply - Button" in
the Administrator Guide.
îš„More
Displays the [Paper Supply] screen.
Refer to "[Paper Supply] Screen" (P.83).
Checking the Remaining Amount of Paper in a Tray
The icons displayed in a tray allows you to check the remaining amount of paper loaded
in the tray.
[Paper Supply] Screen
This screen allows you to select a paper tray from all trays available on the machine.
1 Select a paper tray.
îš„Tray
Allows you to select a paper tray. When [Bypass] is selected, the [Tray 5] screen is
displayed where you can specify a paper type other than plain paper, and non-standard
size paper.
For more information, refer to "[Tray 5] Screen" (P.84).
When the Envelope Tray (optional) is inserted into the slot for Tray 1, you can load
envelopes in the tray. To use the Envelope Tray, prior settings are required in the
System Administration mode.
: Indicates that the remaining amount of paper is 25 to 100%.
: Indicates that the remaining amount of paper is 25% or less.
: Indicates that the tray runs out of paper, or no paper is loaded in the
tray.
You can view the icons to check the
remaining amount of paper in a tray.
To Next Page
Loading...
Need help?
General
